![]() How often do You want information to be sent, Nr of times per second? from 1 to 10 (ForFlight requirement) You might need to open it as UDP exclusively and not as TCP/UDP. Make sure the ports port_udp and port_AHRS are correctly opened in any firewall and router. SPort_Nr = 3 - Only needed if NMEA_Serial = 1, replace the number with the serial port You want to use Host_udp, port_udp = "192.168.0.27", 49002 - Only needed if NMEA_UDP = 1, replace IP with device IP and select preferred port, use the same port in your GPS device. Host_AHRS, port_AHRS = "192.168.0.27", 49002 - Only needed if AHRS_UDP = 1, replace IP with device IP and leave the port as 49002 Remember to comment out the "dofile" line related to this MOD in a or set NMEA_Serial = 0 in this file if you are not going to use it to avoid freezing. I do not know if this freezing behavior exist when a physical serial port is used, since I do not have one to test with. As soon as it listen, DCS will un-freeze. If Bluetooth is used, be aware that DCS will freeze as long as the used device isn't listening to the port. NMEA_Serial = 0 - NMEA sentences via Serial port, you can configure a virtual Bluetooth serial port and connect to a Bluetooth devise What output do You want? 0 = disabled, 1 = enabled, can be severalĪHRS_UDP = 1 - AHRS sentences via UDP (ForFlight, SkyDemon, WingX Pro, FltPlan Go, etc. This "CONFIGURATION" is the only section you need to edit! I don't need to open the port/s myself the way I have things configured. You put your phones IP in "where to connect?"Įxactly how you open the AHRS port on your equipment, I can't really help you with, but I would assume you should add it as outbound since the traffic is exclusively going from your DCS computer to your phone. I don't *really* understand it fully myself -) ![]() Not all of us *really* understand how these things work. You gotta break these things down Barney-style, man. Under "where to connect," am I putting my computer's IP address in the provided spot or my phone/tablet's?Įxactly how do I open the ports "port_udp" and "port_ahrs" in my firewall? My understanding, and therefore what I did, is to go into Inbound Rules and open ports 49002 and/or 4353 with UDP protocol. I honestly don't even know if I'm doing the setup correctly.ĭo I need to enable both AHRS_UDP *and* NMEA_UDP, or just AHRS? I can't get this to connect to FltPlanGo on my phone. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |